8
B
EFORE
O
PERATION
Battery Replacement Method
Check
Turn the power switch on the trans-
mitter to the ON position. Check to
see if the two LEDs light.
If the LEDs fail to light, check the
batteries for insufficient contact in
the case or incorrect battery polarity.
Caution
Always be sure you reinsert the
batteries in the correct polarity order.
If the batteries are loaded incorrectly ,
the transmitter may be damaged.
When the transmitter will not be used
for any short or long period of time
always remove the batteries.
If the batteries do happen to leak , clean
the battery case and contacts thor-
oughly. Make sure the contacts are free
of corrosion.
Battery Disposal
Some states require special handling
when any type of battery is disposed.
Contact the State Agency responsible
for recycling hazardous waste for
procedures in your area.
Battery Alarm Display
When the Green battery level indica-
tor (LED) goes off and the Red LED
flashes, change the batteries immedi-
ately.
Charging Jack
1
Slide the battery cover off the trans-
mitter in the direction of the arrow in
the figure.
2
Remove the used batteries.
3
Load the new AA size batteries .
Pay very close attention to the
polarity markings and reinsert ac-
cordingly.
4
Slide the battery cover back onto
the case.
Charge the Ni-cd battery
by Futaba special charger
(sold separately).
(Only transmitter with charging jack)
Caution
Do not charge a dry cell battery.
Charging a dry cell battery will cause
abnormal heating, etc. and is danger-
ous.
Battery Cover
Red
Green
Battery Level Indicator
Charging Jack
