Instruction Manual
*Windows is registered trademark of Microsoft Corporation.
Connection method
1.Connect the CIU-3 to the USB port
of the PC.
2.Connect the Link-supported device
to the CIU-3.
3.Connect the batteries by referring
t o t h e L i n k - s u p p o r t e d d e v i c e
instruction manual.
4.Set the power switch of the Link
device to ON.
5.Communication with the Link pro-
gram is possible.
When using the CIU-3, please disconnect the other USB Serial Port device from
the USB port on your PC.
Example of connection to Link programs supported device
(The figure below is an example of connection to an S-BUS servo.)
Usage Precautions
Do not disassemble the CIU-3. Do not open the CIU-3 case.
Opening the case may damage the PC board. In this case, PC assembly replacement or repair will become
impossible. There is also the danger of fire and electric shock.
Do not expose the CIU-3 to water or other liquids. Do not touch the CIU-3 when you hands are
wet.
Water droplets entering the CIU-3 may cause trouble. There is also the danger of fire and electric shock.
Do not drop or expose the CIU-3 to strong shock.
It may cause trouble.
Do not set anything on top of the CIU-3.
It may cause trouble.
Do not touch the connectors with your hands. Also, do not connect a dusty or dirty connector.
It may cause trouble.
Handle the PC and peripheral devices in accordance with the instruction manual and cautions
and warnings given in the instruction manual of each product.
Connect to PC USB port
PC-LINK adapter
S-BUS servo
Connect to CIU-3
Connect the batteries to
the Link-supported device
Special Markings
For safety's sake, pay special
attention whenever you see
the marks shown here.
Mark
Meaning
Procedures which may lead to a dangerous condition or cause death or serious
injury to the user if not carried out properly, or procedures where the probability of
superficial injury or physical damage is high.
Procedures where the possibility of serious injury to the user is small, but there is a
danger of injury, or physical damage, if not carried out properly.
Symbol:
:Prohibited
:Mandatory
<When requesting repair>
Reread manual before requesting a repair. If the problem continues, contact your local Futaba dealer. (HCA's Service
Center.)
©FUTABA CORPORATION 2016,04 (1)
FUTABA CORPORATION Phone: +81 475 32 6982, Facsimile: +81 475 32 6983
1080 Yabutsuka, Chosei-mura, Chosei-gun, Chiba 299-4395, Japan
