100
＜ Linkage menu ＞
Variometer
Sets the variometer
on which the alarm
operates.
↑ An upward arrow
indicates the alarm
will sound when the
variometer reaches
above your set value.
↓ A downward arrow
indicates the alarm
will sound when the
variometer reaches
below your set value.
Alarm is chosen from
Buzzer, Voice, and
Inhibit.
Allows Speech to be
turned ON or OFF.
Allows Melody to be
turned ON or OFF.
ŏ
Tap the [Variometer] button in the Telemetry screen
to call the setup screen shown below.
Max. and min. values
s i n c e t h e p o w e r
was turned ON will
display.
*It cannot be used in FASST mode and S-FHSS mode.
*Only receiver voltage and EXT voltage can be used in
FASSTest12CH mode.
*The FASSTest18CH /T-FHSS mode can use all the telemetry
functions.
Type 1
Type 2
Type 3
"Vibrator" type
If the following types are selected, the transmitter
will vibrate during the warning.
First, the set of a reference is required.
1. The model and transmitter to which the
altitude sensor was connected are turned on.
2. Tap to the [Preset] of "Reference" item.
*Atmospheric pressure is changed according to the weather
also at the same air
¿
eld. You should preset before a
À
ight.
*An altitude sensor or GPS sensor must be installed in the aircraft.
Telemetry : Altitude [Variometer]
Displaying data from the
variometer
VARIO is a screen which displays / sets up the
variometer information from an optional altitude
sensor or GPS sensor.
The variometer of the model which is
À
ying can
be known.
If it becomes higher or lower than the setting, an
alarm and/or vibration will alert you.
To ensure that the pilot is aware as to the model's
status, the FX-36 incorporates a different melody
for ascent and descent. Additionally, depending
upon the rate of climb or descent, the tones vary to
indicate whether or not the airplane is climbing or
descending at a rapid rate.
Alert set : variometer
1. Tap Alarm and choose from Bu
]]
er, Voice,
and Inhibit.
2. Choose "Inhibit" for Vibrator if no
t
using the
vibrator alarm. If using vibrator, choose one
of the three types.
3. Tap to the Limit [m/s] item .
4. Adjust the rate using the "
ʈʈ
" "
ʈ
" "
ʆ
" "
ʆʆ
"
buttons.
Initial value: +1m
Adjustment
range-50m/s~+50m/s
(
Ń
Limit
≧
Ņ
Limit)
*When the screen is tapped for one second, the rate is reset
to the initial value.
5. To terminate the input and return to the
original state, push the H/E button.
● If this is set to Mode1-4,
a rise and dive are told
by a different melody.
Mode 1 : Little rise/dive
→ Melody changes
: sensitively
Mode 4 : Big rise/dive
→ Melody changes
: insensible
ŏ
Return to
Linkage menu
