139
＜ Model menu (Airplane/Glider/Multicopter Functions) ＞
RUDDER 2
RUDDER
RUDDER
V-TAIL
RUDDER 2
Winglet
RUDDER 1
Winglet
at Flying wing
at Flying wing
( )
( )
AIL 3
AIL 3
(Chip Aileron)
(Chip Aileron)
AIL1
(Main Aileron)
AIL 2
(Main Aileron)
Rudder → Aileron
[Corresponding model type]:
Airplane/glider, general
This function is used when you want to mix
the ailerons with rudder operation. It is used
when rudder is applied during roll maneuvers,
knife edge, etc. of stunt planes. It can be used to
bank scale models, large models, etc. like a full
size plane.
ŏ
A mixing curve can be set.
ŏ
Mixing during
Á
ight can be turned ON/OFF by
setting a switch. (Always ON at [--] setting)
ŏ
Linking can be set: Link this mix to other mixes.
ŏ
The mixing rate can be
À
ne-tuned by setting a VR.
Setting method
ŏ
Tap [INH].
(ON is displayed.)
ŏ
When setting a switch, tap to the [--] item
of the switch and tap the screen to call the
selection screen. Then, select the switch and
set its ON direction. (Always ON at "--" setting)
(For a description of the switch selection
method, see back of this manual.)
ŏ
When setting a VR, tap to the Fine tuning
"--" item and tap the screen to call the
selection screen and then select the VR. The
adjustment rate can be set.
The VR operation mode can also be set.
(For a description of the
À
ne tuning VR setting
method, see the description at the back of
this manual.)
ŏ
A mixing curve can be set.
(For a description of the curve setting
method, see the back of this manual.)
ŏ
When linking: tap the [Link] item. (ON is
displayed.)
Currently selected condition name
● Mixing curve setting
(For a description of the
setting method, see the
description at the back
of this manual.)
L e f t / r i g h t o v e r a l l
adjustment at Rate A
and Rate B
Activate the function by
tapping the [INH].
Condition group/single
mode selection (Gr. /Sngl)
The ON/OFF switch of
mixing is chosen.
Fine tuning
setting
ŏ
Select [Rudder
ń
Aileron] at the model menu
and call the setup screen shown below.
To set linking, tap to
the [OFF] item
ŏ
Return to Model menu
