167
＜ Model Menu (Helicopter Functions) ＞
＊ Gyro gain channel
Gyro : CH5
For the FASSTest12CH, Gyro/RUD is 6ch. The gyro sensitivity adjustment connector connects to 6ch.
＊ Gyro gain channel
Gyro RUD : CH5
For the FASSTest12CH, Gyro/RUD is 6ch.
Gyro2 AIL : CH9
Gyro3 ELE : CH10 For the CGY750, simply connect the S.BUS; functions do not need to be set.
(For the FASSTest12CH, change Gyron/RUD to 6ch.)
Usage example #1: Using gyro for only the rudder and adjusting sensitivity for each condition
Usage example #2: Using 3-axis gyro CGY750 and adjusting sensitivity for each condition
Because sensitivity changes for
h o v e r i n g a n d i d l e u p , p e r f o r m
switchover for each condition and
adjust sensitivity.
Because sensitivity changes for
h o v e r i n g a n d i d l e u p , p e r f o r m
switchover for each condition and
adjust sensitivity.
B e c a u s e t h e
sensitivity is switched
(Sngl) per condition,
Rate2 and Rate3 are
not used.
B e c a u s e t h e
sensitivity is switched
(Sngl) per condition,
Rate2 and Rate3 are
not used.
T a p p i n g h e r e w i l l
let you select either
N o r m a l o r AV C S f o r
each of the three axes.
This is all that is needed
for use in this case.
This is all that is needed
for use in this case.
Tapping here will let you
select either Normal or
AVCS.
Set gain of a rudder
Set gain of a rudder
Set gain of an aileron
Set gain of an elevator
ŏ
Select [Gyro] at the
model menu and call
the setup screen.
ŏ
Select [Gyro] at the
model menu and call
the setup screen.
