86
＜ Linkage menu ＞
Target time
Time ：
Alarm :
Last ten seconds
Last twenty seconds
One short
beep
Two short
beeps
Also
beep
Continue counting
with displaying a
minus (-) sign.
Timer
Timer setting
The Timer function may be set for
any desired time, i.e. engine run time,
specified times for competitions, etc.
Two independent timers are provided
for your use. The timers are stored
independently with each model, meaning
that when you switch between model
setups, the timer associated with the new
model is brought up automatically.
The timers may be set to start and stop
from the motion of any switch or stick.
You may set the ON and OFF directions
freely. Each timer has a capacity of up to
59 minutes 59 seconds.
Each timer may be set for count-down or count up
operation with a target time.
If a target time is set and the timer reaches the set time, a
buzzer sound for each count is generated.
A timer on the home screen starts and stops its
countdown directly from there when tapped.
Tapping and holding the display will reset the timer.
[Start/Stop] → Home screen
Timer 1
Timer 2
Elapsed: Minute-by-minute
alarm starting from 00:00
R e m a i n d e r : M i n u t e - b y -
minute alarm counting down
from a designated time
Up timer/Down timer selection
1. Tap the mode button and select the type of
timer.
2. Timer time setting.
Tap the Mode minutes or seconds button.
Value input buttons appear on the screen.
8
se these buttons to set the timer time.
Start/Stop/Reset switch setting
1. Tap the Start/Stop/Reset SW "--" button to
call the
Switch
!
screen, and then select the
switch and its ON direction.
(For a detailed description of the selection
method, see [Switch selection method] at
the back of this manual. The timer switches
can be set for each condition.)
[Inhibit] → [Type1-4]
If it carries out like this,
a vibration function
will work.
ŏ
Select [Timer] at the linkage menu and
call the setup screen shown below.
ŏ
Return to
Linkage menu
OFF: Turning the power OFF and switching models will reset the timer.
ON: Previous timer is put into memory and will restart from where it stopped.
A Buzzer or Speech
can be chosen
Constant:The alarm
does not stop
One time: Stop the
alarm at once
