93
＜ Linkage menu ＞
*For some transmitters (e.g., T6K), when the start slot of a
sensor is changed, the sensor cannot be used.
WARNING
This procedure changes the slot number of one
registered sensor.
Sensor slot change
1. Connect the sensor to the FX-36 as shown in
the
À
gure above.
2. Tap
´
Change slot
µ
on page 3/3 of the
Sensor
!
screen.
3. Tap
´
Read
µ
.
4. A sensor details screen appears.
5. The current start slot is displayed. To change
a start slot, a
＋
Ɇ
button, tap.
（
Cannot be
set to a slot that cannot be allocated like the
table of all pages.
）
6. Tap to the
´
Write
µ
.
Sensor : Change slot
This page is set when using multiple telemetry sensors
of the same type.
);
SENSOR
ŏ
Call page 3/3 from the [Sensor] menu.
ŏ
Tap the [Change slot] button
in the Sensor screen to call the
setup screen shown below.
ŏ
Return to
Linkage menu
Do not disconnect or turn transmitter
power OFF while telemetry sensor data
is being saved.
Sensor save data will be lost, resulting in
malfunction.
*It is not necessary to carry out
multiple battery connections like
a T18M
=
/T14SG.
