97
< Linkage menu >
Temperature
Sets the temperature
on which the alarm
operates.
↑ An upward arrow
w i l l s h o w t h a t a n
alarm will sound when
the temperature rises
above the set value.
↓ A downward arrow
w i l l s h o w t h a t a n
alarm will sound when
the temperature drops
below the set value.
Alarm is chosen from
Buzzer, Voice, and
Inhibit.
Allows Speech to be
turned ON or OFF.
ŏ
Tap the [Temperature] button in the Telemetry
screen to call the setup screen shown below.
Max. and min. values
s i n c e t h e p o w e r
was turned ON will
display.
Telemetry : Temperature
Displaying data from the temperature
Temperature is a screen which displays/sets
up the temperature information from an optional
temperature sensor.
The temperature of the model (engine, motor,
battery, etc.) which is
À
ying can be displayed.
If it becomes higher or lower than the setting, an
alarm and/or vibration will alert you.
Alert set : Temperature warning
1. Tap Alarm and choose from Bu
]]
er, Voice,
and Inhibit.
2. Choose "Inhibit" for Vibrator if no
t
using the
vibrator alarm. If using vibrator, choose one
of the three types.
3. Tap to the Limit [
℃
] item .
4. Adjust the rate using the "
ʈʈ
" "
ʈ
" "
ʆ
" "
ʆʆ
"
buttons.
Initial
value:
Ń
100
℃
Ņ
0
℃
Adjustment range: -20
℃
~200
℃
(
Ń
Limit
≧
Ņ
Limit)
*When the screen is tapped for one second, the rate is reset
to the initial value.
5. To terminate the input and return to the
original state, push the H/E button.
*A temperature sensor must be installed in the aircraft.
*It cannot be used in FASST mode and S-FHSS mode.
*Only receiver voltage and EXT voltage can be used in
FASSTest12CH mode.
*The FASSTest18CH /T-FHSS mode can use all the telemetry
functions.
Type 1
Type 2
Type 3
"Vibrator" type
If the following types are selected, the transmitter
will vibrate during the warning.
ŏ
Return to
Linkage menu