10
GY520 Link
Control Response
Initial value: Left=7, right=7, setting range: 0-20
Sets the rudder operation delay. The left and right delays can be set separately. When
the set value is increased, the delay increases. When the rebound when the tail stops
is large, it can be reduced by increasing the delay.
AVCS Response
Initial value: Left/In=7, Left/Out=7, Right/In=7, Right/Out=7, setting range: 0-20
Adjusts the tail operation response speed. When the set value is increased, the
response speed decreases. "In" is the delay setting when the rudder stick is moved to
the left and right from the neutral position. "Out" is the delay setting when the rudder
stick is returned to the neutral position from the left and right. The left and right in/out
delay can be set separately. The rudder operation feeling and rebound characteristic
when the tail stops change just like the "Control Response" setting.
Pirouette Consistency
Initial value=7, setting range: 1-10
It selects the pirouette control feeling at the rudder input changes. Adjusting ranges
are from 1 to 10. The value 10 is a most stiff of the pirouette control, the value 1 is to
be a moderate control. Select with preferable rudder control style.
• EXP
Initial value: Normal=-10, AVCS F3C=-40, AVCS 3D=-20, setting range: -100-+100
Set the operation feeling near the rudder stick neutral position. When the set value
is "-" side, operation near the neutral position becomes gentle. Operation is like EXP
setting of the transmitter.
• AVCS setting
Yaw Rate
Initial value=100, setting range: 30-110
Sets the tail rotational speed. When the rudder operating amount of the transmitter
is 100% and the parameter setting is 100, the initial value is set to 450 deg/sec in
the F3C mode and to 720 deg/sec in the 3D mode. The maximum control speed of
the GY520 is 800 deg/sec. Care is necessary because if set above this value, the
helicopter will pirouette at a very high speed exceeding the gyro control range.
Gain
Initial value=40 setting range: 0-50
Sets the AVCS sensitivity. When the set value is increased, the holding capacity of
the tail increases, but there is a tendency toward hunting and for the tail rebound to
increase.
Range
Initial value=300 setting range: 100-500
