FUTABA CORPORATION
1080 Yabutsuka, Chosei-mura, Chosei-gun, Chiba-ken, 299-4395, Japan
Phone: +81 475 32 6982, Facsimile: +81 475 32 6983
©FUTABA CORPORATION 2013, 4 (1)
Compliance Information Statement
(for U.S.A.)
This device, trade name Futaba Corporation of America, model number R304SB, complies
with part15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
(3) This module meets the requirements for a mobile device that may be used at separation
distances of more than 20cm from human body.
To meet the RF exposure requirements of the FCC this device shall not be co-located with
another transmitting device.
The responsible party of this device compliance is:
Futaba Service Center
3002 N Apollo Drive Suite 1, Champaign, IL 61822 U.S.A.
TEL (217)398-8970 or E-mail: support@futaba-rc.com (Support)
R304SB Specifications:
(
T-FHSS
system,
S.BUS2
, 4-channel receiver)
s2ECEIVINGON'(ZBAND
s3YSTEM
T-FHSS
system
At Normal/High speed mode (auto detection)
s
Power requirement Rated voltage: 4.8V-7.4V / Usable voltage: 3.5-8.4V
s &3AND"ATTERY&3FUNCTION)TISSETACCORDINGTOTHETRANSMITTERUSED
s "ATTERY&3VOLTAGE3ETITWITHTHETRANSMITTERARBITRARILY
s3IZEXXvXXMM
s7EIGHTOZG
2
Receiver
HUB
Temperature
sensor
RPM sensor
Voltage sensor
Switch
Battery
Telemetry sensors
(Option)
Steering servo
Throttle servo
CH4
CH1
C o l l e c t m a n y
t e l e m e t r y
sensors
by
HUB
and connect
them to
S.BUS2
port.
S.BUS2
CH2
,WFRQQHFWVZLWKSRUWZKLFKLVQRWXVHGك
*When all the ports are used, connect
a battery using HUB or Y-harness.
The Example of Connection
This device, trade name Futaba Corporation of America, model number R304SB, complies
with part15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
CAUTION:
To assure continued FCC compliance:
1. Any changes or modifications not expressly approved by the grantee of this device could void the
user's authority to operate the equipment.
2. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
The responsible party of this device compliance is:
Futaba Service Center
3002 N Apollo Drive Suite 1, Champaign, IL 61822 U.S.A.
TEL (217)398-8970 or E-mail: support@futaba-rc.com (Support)
ʳ
ءขฤٽ
܅פሽंᘿ୴ࢤሽᖲጥᙄऄ
ʳรԼԲයΕรԼයය֮ࡳʳ
1.
ᆖীڤᎁᢞٽհ܅פ୴᙮ሽᖲΔॺᆖױΔֆΕᇆࢨࠌشृ݁լ
ᖐ۞᧢ޓ᙮ΕףՕפࢨ᧢ޓૠհࢤ֗פ౨Ζ
2.
܅פ୴᙮ሽᖲհࠌشլᐙଆڜ٤֗եឫٽऄຏॾΙᆖ࿇ڶեឫ
ွழΔᚨمܛೖشΔࠀޏ۟ྤեឫழֱᤉᥛࠌشΖ
ছႈٽऄຏॾΔਐࠉሽॾऄࡳ܂ᄐհྤᒵሽຏॾΖ
܅פ୴᙮ሽᖲႊݴ࠹ٽऄຏॾࢨՠᄐΕઝᖂ֗᠔᛭شሽंᘿ୴ࢤሽᖲໂ
հեឫΖ
This device, trade name Futaba Corporation of America, model number R304SB, complies
with part15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
CAUTION:
To assure continued FCC compliance:
1. Any changes or modifications not expressly approved by the grantee of this device could
void the user's authority to operate the equipment.
2. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment.
To meet the RF exposure requirements of the FCC this device shall not be co-located with
another transmitting device.
The responsible party of this device compliance is:
Futaba Service Center
3002 N Apollo Drive Suite 1, Champaign, IL 61822 U.S.A.
TEL (217)398-8970 or E-mail: support@futaba-rc.com (Support)
ʳ
ءขฤٽ
܅פሽंᘿ୴ࢤሽᖲጥᙄऄ
ʳรԼԲයΕรԼයය֮ࡳʳ
1.
ᆖীڤᎁᢞٽհ܅פ୴᙮ሽᖲΔॺᆖױΔֆΕᇆࢨࠌشृ݁լ
ᖐ۞᧢ޓ᙮ΕףՕפࢨ᧢ޓૠհࢤ֗פ౨Ζ
2.
܅פ୴᙮ሽᖲհࠌشլᐙଆڜ٤֗եឫٽऄຏॾΙᆖ࿇ڶեឫ
ွழΔᚨمܛೖشΔࠀޏ۟ྤեឫழֱᤉᥛࠌشΖ
ছႈٽऄຏॾΔਐࠉሽॾऄࡳ܂ᄐհྤᒵሽຏॾΖ
܅פ୴᙮ሽᖲႊݴ࠹ٽऄຏॾࢨՠᄐΕઝᖂ֗᠔᛭شሽंᘿ୴ࢤሽᖲໂ
հեឫΖ
