140
Butterfly
[Corresponding model type]: Glider, 2 ailerons or more
This function allows powerful brake operation
by simultaneously raising the left and right
ailerons and lowering the flaps (camber flap,
brake flap).
This setting will allow the ailerons to be raised
while the flaps are simultaneously lowered.
Butterfly (crow) produces an extremely efficient
landing configuration by accomplishing the
following:
1. Slow the aircraft’s velocity.
2. Provide washout at the wing tips to reduce
the tendency to tip stall.
3. Create more lift toward the center of the
wing allowing it to fly at a slower speed.
● Mixing during flight can be turned ON/OFF by
setting a switch. (Always ON at [--] setting)
● The butterfly operation reference point can be
offset. When the screen is tapped with the offset
item selected when operated to the position to
be changed, the reference point is offset. If the
reference point is offset too much, unexpected
operation may be performed.
● The ailerons and flaps operation speed can be
adjusted. (In side/Out side)
● A delay can be set for each condition. A cut
switch which can turn OFF the delay function can
also be set.
● The differential rate can be adjusted.
*When servo binding occurs when setting the ailerons and
flaps in butterfly mixing, use the AFR function to adjust the
rate.
● Select [Butterfly] at the model
menu and call the setup screen
shown below.
*The display screen is an example. The actual
screen depends on the model type.
When using this
function, Tap [INH].
(ON is displayed.)
Condition group/single
mode selection (Gr. /
Sngl)
The ON/OFF switch of
mixing is chosen.
Condition delay setting
Condition delay cut
switch
To next page
The differential rate
can be adjusted.
In speed
Out speed
（First）0 ～ 27（Slowly）
（First）0 ～ 27（Slowly）
*The display screen is an example. The actual
screen depends on the Model Type.
When offsetting the butterfly operation
reference point, operate to the throttle
stick point you want to change and then
touch the Offset button. The reference
point displays 0%. When [Yes] is touched,
the reference point is changed. Then,
"Initialize elevator curve?" appears,
allowing you to confirm your setting.
*When differential rate is "-", the calculation method of UP/
DOWN and a direction become reverse.
*When differential rate is "+", Up rate is decrease and DOWN
rate is increase.
Summary of Contents for T16IZ
Page 1: ...1M23Z07702 WEB FULL MANUAL ...
Page 228: ......
