162
Pitch trim (Hovering pitch, high pitch, low pitch)
The hovering pitch, low pitch, and high pitch trim setup screen can be called from the Pitch curve setup
screen.
Hovering pitch trim
setting
Low/high pitch trim
setting
Hovering pitch trim
The Hovering Pitch trim function trims the pitch
near the hovering point. Normally, it is used with
the hovering condition. The hovering pitch can be
fine tuned for changes in rotor speed accompanying
changes in temperature, humidity, and other flight
conditions. Adjust the hovering pitch so that
rotor speed is constant. This function can be used
together with the hovering Throttle Trim function
for more delicate operation.
Setting method
● When using only the hovering (normal)
condition, switch the group mode to the
single mode (initial setting) before setting.
● Tap [INH]. (ON is displayed.)
● Select the adjustment knob.
Selection example: LD
● The trim operation mode (Mode: Center/
Normal) can be selected.
Center mode: Maximum amount of change
near center by center trim operation
(recommended)
Normal mode: Normal trim (parallel
movement trim) operation. The advantage
of using this mode is that the hovering pitch
can be adjusted without changing the
curve.
● Trim adjustment range (Range) setting
When this value is made small, trim can only
be used near the center.
● The trim rate can be adjusted and the
operation direction can be changed.
High Pitch/Low Pitch Trim
High Pitch/Low Pitch Trim is the pitch servo high
side and low side trim function.
Setting method
● When setting the adjustment knobs common
to all the conditions, set them in the group
mode.
● Tap [INH]. (ON is displayed.)
● Select the adjustment knobs.
Selection example: LS (high side), RS (low
side)
● The trim rate can be adjusted and the
operation direction can be changed.
● Trim acts as high side or low side trim with the
center as the standard.
●Return to Model menu
Summary of Contents for T16IZ
Page 1: ...1M23Z07702 WEB FULL MANUAL ...
Page 228: ......
