166
Throttle hold
This function sets the throttle cut position for
autorotation. The throttle position can also be set to
an idling position. Setting of these 2 positions can
be selected by switch. This allows use for switching
during training.
Exampleofuse
● Since throttle hold has 2 modes (Cut) and
(Idle), using it in the Idling mode during
training and in the Cut mode when
stopping the engine at contest, etc. is
convenient.
Note: When throttle hold is set to ON in the normal
condition, throttle hold acts and the throttle servo
is deactivated. Always set throttle hold to ON in the
hold condition.
Setting method
● Operation mode selection
Manual mode(Manual): The throttle hold
function is operated by switch operation
only.
Auto mode(Auto): The throttle hold function
operation is linked to the throttle stick
position.
Auto position setting: When the auto mode is
selected, the throttle position (auto position)
can be selected. Move the throttle stick to
the position you want to set and tap the
screen. (Auto position is displayed.)
● Hold position adjustment
Throttle Hold (Cut) sets the throttle cut
position. Adjust it so that the carburetor is fully
closed.
Throttle Hold (Idle): Make this adjustment to
maintain idling for training. Adjustments can
be made based on the throttle curve idle
position.
● The throttle servo operating speed can be
adjusted. (Speed)
● Throttle cut or training function can be
switched by hold function selector switch.
Operation precautions
WARNING
When starting the engine, confirm that
the idle up condition and throttle hold
condition are OFF.
● Select [Throttle hold] at the model
menu and call the setup screen shown
below.
Current position
Hold position
Engine cut setting
Engine idle setting
Set to the engine
stop position.
Set to the idling
position.
●Return to Model menu
Summary of Contents for T16IZ
Page 1: ...1M23Z07702 WEB FULL MANUAL ...
Page 228: ......
