143
Trim mix 1/2
[Corresponding model type]: Glider, general
These functions call the ailerons, elevators, and
flaps (camber flaps, brake flaps) trim offset rates
preset according to the flight state.
The amount of ailerons, elevator, and flaps
(camber flap, brake flap) trim offset can be set to a
switch.
As an example
Trimmix1
can be set up for
launching, with speed flaps and ailerons dropped,
and a slight amount of up elevator.
Trimmix
2
can be used for high speed flying, with both
ailerons and speed flaps reflexed slightly, and a bit
of down elevator.
The trim functions can be activated during
flight by setting a switch. To prevent sudden trim
changes when switching flight conditions, a delay
can be set to provide a smooth transition between
the two. Trim mix 2 will have priority over Trim
mix 1.
The offset rate of ailerons, flaps and elevators can be adjusted.
Tap to the corresponding setting item. Adjust the rate.
Example
1. Move to the [INH] item
.
Set the trim mix function to
[ON].
*When separating the settings for each condition, move to
the [Group] item and set it to [Single].
2. Select the ON/OFF switch.
3. Select the [Manual] or [Auto] mode.
In the [Auto] mode, also select an auto SW. This
switch can be linked to a stick, etc.
<Speed>
In: The operation speed at switch ON can be set.
Out: The return speed at switch OFF can be set.
<Fine Tuning>
The offset rate can be varied in the Fine Tuning
numeric range set at screen by VR, etc. selection.
<Condition Delay>
When flight conditions are set, the operation speed
can be set for each condition. Condition delay
operation can be interrupted and each rudder
quickly returned to its original position by selecting a
cut switch.
● Select [Trim mix1 or 2] at the model
menu and call the setup screen
shown below.
When using this
function, Tap [INH].
(ON is displayed.)
The ON/OFF switch of
mixing is chosen.
Manual/Auto mode
selection
Manual: Switches the
function ON/OFF by
switch
Auto: Trim mix function
call can be linked to a
stick, etc. A stick switch,
etc. separate from the
function ON/OFF switch
is set.
Condition delay setting
Condition delay cut
switch
In speed
Out speed
（First）0 ～ 27（Slowly）
（First）0 ～ 27（Slowly）
*The display screen is an example. The actual
screen depends on the Model Type.
When a fine tuning VR
is set, the trim rates
of ailerons, flaps and
elevators can be adjusted.
To next page
●Return to Model menu
The value inside the
parentheses shows the
current rudder position.
Summary of Contents for T16IZ
Page 1: ...1M23Z07702 WEB FULL MANUAL ...
Page 228: ......
