76
● Tap the [Fail safe] button in the Linkage menu to call the setup screen shown below.
Fail safe
Sets the servos' operating position when transmitter signals can no
longer be received or when the receiver battery voltage drops.
The Fail safe function is used to set up positions
that the servos will move to in the case of radio
interference. Defines servo position when signals are
lost and when receiver battery voltage becomes low.
You may set either of two positions for each channel:
Hold, where the servo maintains its last commanded
position, or fail safe, where each servo moves to
a predetermined position. You may choose either
mode for each channel.
The T16IZ system also provides you with an
advanced battery monitoring function that warns
you when the receiver battery has only a little
power remaining. In this case, each servo is moved
to the defined failsafe position. The battery failsafe
may be released by operating a predefined control
on the transmitter (default is throttle). Do not
continue to fly. Land as soon as possible. Remember,
if the predefined control suddenly moves to a
Fail safe setting procedure
Decide which channels you want to go to preset
positions, and which ones you want to maintain
their last commanded position. To select the fail
safe mode you wish to set, use the F/S button. This
button toggles between the two modes. (Hold, F/S)
F/Smodesetting:
1. Tap the F/S button of the channel you want
to set, and set that channel to the [F/S]
mode.
2. Hold the corresponding stick, control, slider,
or other control in the position you want the
servo to move to when the fail safe function
is activated, and tap the F/S position button.
That position is displayed in percentage.
*When you want to return that channel to the Hold mode, tap
the [F/S] button again.
Battery fail safe setting procedure
To select the B.F/S mode, tap the [B.F/S] button.
Each time the button is tapped, it toggles between
[OFF] and [B.F/S].
B.F/Ssetting:
position you did not command, land at once and
check your receiver battery.
Do not continue to fly. Land as soon as possible.
Defines servo position when signals are lost and
when receiver battery voltage becomes low.
WARNING
For safety, always set the fail safe functions.
■Especially set the throttle channel fail safe function so that the
servo moves to the maximum slow side for airplanes and to the
slow side from the hovering position for helicopters. Crashing
of the model at full high when normal radio waves cannot be
received due to interference, etc., is very dangerous.
■If fail safe is reset by throttle stick movement, the fail safe
may be mistaken as an engine malfunction and will be reset
at low throttle and the model will continue to fly. If you have
any doubts, immediately land.
1. Tap the [B.F/S] button of the desired channel
to set it to the B.F/S mode.
2. Hold the corresponding stick, VR, slider,
or other control in the position you want
the servo to move to when the battery fail
safe function is activated, and tap the F/S
position button. This position is displayed in
percentage.
*When you want to return that channel to OFF, tap the [B.F/S]
button again.
Battery Fail safe release function
This function releases the predefined control from
its held position after indicating that your receiver
battery is low.
1. Enter the control setting screen by tapping
the Battery F/S release button. Now, you may
choose whether moving the throttle resets
the condition, or select a stick or switch to
deactivate it. To set a desired throttle release
position, move the throttle stick to the point
at which you wish the B.F/S to be released.
●Return to
Linkage menu
Summary of Contents for T16IZ
Page 1: ...1M23Z07702 WEB FULL MANUAL ...
Page 228: ......
