81
Tapping this will change
INH to either OFF or ON
and activated.
Tapping this will pull up the
hardware selection screen.
Select the idle down switch
and ON-OFF direction.
This is the current position bar for the
throttle stick. Throttle cut will only
function when the throttle stick is more
than halfway into the low throttle range.
This is the idle down
throttle position. Tapping
this will display value input
buttons on-screen. Set the
engine's max. low position.
Range:
（↑）-100 ～ +100（↓）
Pressing and holding a
value will reset it to 0.
Idle down
Lowers the engine idling speed.
The Idle down function lowers the engine's idle
by flipping a switch with the throttle stick at idle.
The action is not functional at high throttle to avoid
accidental dead sticks. The switch’s location and
direction must be chosen, as it defaults to "
－－ "
.
● Select [Idle down] at the linkage menu
and call the setup screen shown below.
Idle down setting procedure
1. Tap the "INH" button to activate the Idle
down function.
2. Idle down function switch setting:
Tap the "--" button to call the <Hardware
select> screen, and then select the switch
and its ON direction.
(For a detailed description of the selection
method, see [Switch selection method] at
the back of this manual.)
●Return to Linkage menu
3. Offset rate setting:
Tap the offset rate button. Value input
buttons appear on the screen.
Use these buttons to adjust the offset rate.
●Initial value: 0%
●Adjustment range: -100%~100%
*(-)becomes an idle up.
To exit the setting, tap the [Idle down]
button.
Landing
Idling, lower
Offset rate
Summary of Contents for T16IZ
Page 1: ...1M23Z07702 WEB FULL MANUAL ...
Page 228: ......
