TERACROSS
Horizontal and vertical leveling
Push the switch (4) up. The Teracross has 5 workingmodes.
To change the workingmodes, push the LINE-button (7).
Mode 1: Horizontal mode. Only the horizontal laserline is visible
Mode 2: Vertical mode. Only the vertical laserline is visible
Mode 3: Cross mode. Both laserlines, horizontal and vertical, are
visible.
Mode 4: Point mode: Only the two points, top and bottom, are
visible
Mode 5: Cross-Point mode.
All 5 modes can be used with or without automatic selfleveling.
If automatic selflevelling is put off, it means the laserlines will be
visible even when the device is more than 5° out of level.
Work with a receiver
If you like to work with a receiver, push the MODE-button (8). The
pulse function is activated and the pulse indicator (10) will light up.
Turn off the device
To turn off the device, push the on/off button (4).
GENERAL
Description
The following directions should enable the person responsible for
the product, and the person who actually uses the equipment, to
anticipate and avoid operational hazards. The person responsible
for the product must ensure that all users understand these direc-
tions and adhere to them.
Adverse Use
Use of the product without instruction.
Use outside of the intended limits.
Disabling safety systems.
Removal of hazard notices.
Opening the product using tools, for example screw- driver, unless
this is specifically permitted for certain functions.
Modification or conversion of the product.
Use after misappropriation.
Summary of Contents for 013.02
