MANUAL
250.120RC – DISTY 120RC [EN]
V1.0 – 09.2022
15
Activate the camera again with the camera button [8] to measure the second distance.
Make the cross, which is on the screen, point exactly your target.
Press the measuring / ON button [3] to activate the measuring tool, press the
measuring / ON button [3] a second time to measure the distance.
Press the camera button [8] to deactivate the camera. The measuring result is now
registered and will be shown on the second Auxiliary display line [g
2
]
(Repeat this last step if your function requires a third value. The result of this third value
will be visible on the third Auxiliary display [g
1
])
After measuring the last needed distance, deactivate the camera. The result of the
function will be shown on the Mayor display area [h].
5.
Angle values on top of the screen
The device shows the tilt angle [d].
The range of this angle is always between -90.0° and 90.0°.
The unit, which can be chosen in the settings, is ° of % (slope).
TIPS
The device can be used with AAA batteries, alkaline of NiMh rechargeable batteries.
ONLY IN CASE NiMH BATTERIES ARE USED, you may charge this batteries using the Micro
USB socket [2] on the side of the device.
DO NOT USE THE MICRO USB SOCKET IN COMBINATION WITH ALKALINE BATTERIES
You may get some warning information.
Message
Meaning
Solution
ERR 1
Received signal is too weak
Chose a surface with a stronger
reflectance or use a reflector
ERR 2
Received signal is too strong
Chose a surface with a weaker
reflectance or use a reflector
ERR 3
Low Power
Replace (or recharge in case of
rechargeable batteries) the batteries
DO NOT RECHARCHE WHEN
ALKALINE BATTERIES ARE USED
