GYRO GS
47
EN
Fonction Hold
•
The tilt function avoids measuring errors in case the instrument moved unintentionally
after it was fully set up (e.g. a gurt of wind, unstable floor, an external manipulation…).
In those cases, the tilt function will automatically stop the spinning of the laser head. It
is recommended to always turn on the tilt function when working with the device over
large distances.
•
Press the Tilt button (16) to activate the tilt function. After 30 seconds, the device will
auto control it’s position. The laser head will immediately stop spinning after the smallest
movement and an exclamation mark (!) will be displayed.
•
Press the Tilt button (16) again or switch off and on the device to continue working.
•
The TILT symbol is displayed.
•
WATCH OUT: The Tilt function is automatically activated when setting a digital slope. In
the digital slope mode, the Tilt function cannot be deactivated.
Récepteur laser« Gyro Tracer
•
Use the laser receiver with strong light intensity, like for example working outside and for
working at large distance
•
If you have chosen another receiver, use the manual that is delivered with it.
•
Remove foile protection from the device.
•
Open the battery place and place the battery as the polarisation indicates.
•
Turn the receiver on by key (16) , the battery indicator will light up in the lcd display on
the left bottom.
•
On the right top of the lcd display, the precision mode is indicated. You can change this by
pressing key (20). This fine adjustment has one lying bar, and the coarse adjustment has 2
lying bars.
•
ATTENTION: each time the device is turned on the coarse adjustment is activated.
•
ATTENTION: for an optimal reception, make sure the laser is at the highest spinning speed
(600 rpm)
•
Move the laser receiver up and down in the horizontal position to detect the horizontal
laser beam.
•
As soon as the receiver area (19) detects the laser, the laser position indicator (18) will light
the LCD’s up and will indicate the direction where the laser beam precisely will be.
•
If the indicator arrow changes in one bar, the laser beam is precisely in the middle of the
receiving field. (19) Use the marking line when appropriate.
•
The measuring rod holder allows you to set up the laser receiver on measuring sticks, with
this you can simply calculate height differences.
Summary of Contents for Gyro GS
