MULTICROSS 3D COMPACT
7
MANUAL
GENERAL
Description
The following directions should enable
the person responsible for the product,
and the person who actually uses the
equipment, to anticipate and avoid op-
erational hazards. The person responsi-
ble for the product must ensure that all
users understand these directions and
adhere to them.
Adverse Use
∙ Use of the product without instruction.
∙ Use outside of the intended limits.
∙ Disabling safety systems.
∙ Removal of hazard notices.
∙ Opening the product using tools, for
example screwdriver, unless this is
specifically permitted for certain func-
tions.
∙ Modification or conversion of the
product.
∙ Use after misappropriation.
∙ Use of products with obviously recog-
nizable damages or defects.
∙ Use with accessories from other manu-
facturers without the prior explicit ap-
proval of FUTECH.
∙ Inadequate safeguards at the work
site, for example when using on or
near roads.
∙ Deliberate dazzling of third parties.
∙ Controlling of machines, moving ob-
jects or similar monitoring application
without additional control and safety
installations.
WARNING
Adverse use can lead to injury, malfunc-
tion and damage. It is the task of the
person responsible for the equipment to
inform the user about hazards and how
to counteract them. The product is not
to be operated until the user has been
instructed on how to work with it.
LIMITS OF USE
Environment
Suitable for use in an atmosphere appro-
priate for permanent human habitation:
not suitable for use in aggressive or ex-
plosive environments.
DANGER
Local safety authorities and safety ex-
perts must be contacted before working
in hazardous areas, or in close proximity
to electrical installations or similar sit-
uations by the person in charge of the
product.
RESPONSIBILITIES
Manufacturer of the product
Laseto N.V. Kelderveld 37, 2500 Lier,
Belgium, BE0808.043.652, hereinafter
referred to as FUTECH, is responsible
for supplying the product, including the
user manual and original accessories, in
a completely safe condition.
Manufacturers of non FUTECH
accessories
The manufacturers of non FUTECH ac-
cessories for the product are responsi-
ble for developing, implementing and
communicating safety concepts for their
products, and are also responsible for
the effectiveness of those safety con-
cepts in combination with the FUTECH
product.
Person in charge of the product
The person in charge of the product has
the following duties:
∙ To understand the safety instructions
on the product and the instructions in
the user manual.
∙ To be familiar with local regulations
relating to safety and accident preven-
tion.
∙ To inform FUTECH immediately if the
product and the application becomes
unsafe.
