· Set an electronic slope using the device keypad
When the manual slope is active, standard the Horizontal LED [a] and Vertical
LED [f] are light up. This means you can use the Horizontal lines button [4] and
the Vertical lines button [5] to set the desired slope on the x-axis (indicated on
the keypad of the device).
Switch to the y-axis by pressing the Receiver button [7]. The Vertical LED [f] and
the Receiver Mode LED [g] are light up. This means you can use the Vertical
lines button [5] and the Receiver button [7] to set the desired slope on the y-ax-
is (indicated on the keypad of the device).
To switch back to the x-axis, press the Horizontal lines button [4].
· Set an electronic slope using the remote control
When the manual slope is active you can use the 4 arrows on the remote control
(UP button [8], LEFT button [9], RIGHT button [10], DOWN button [11]) to set the
desired slope. The LEFT button [9] and RIGHT button [10] are used to set the
slope on the x-axis, the UP button [8] and DOWN button [11] to set the slope on
the y-axis.
To turn off the manual slope, press the power button [1] for approx. 2 seconds OR
press the slope button [2] on the remote control again. The Level/Slope LED [d]
starts blinking green (levelling) and the Levelling symbol [G] flashes on the display
of the remote control untill the device is levelled again.
Digital Slope
The Procross 8.0 DS offers the possibility to set a digital slope. You can add the
percentage for the x- and y-axis and the device will set the slope for you.
Activating the digital slope can only by using the remote control. Make sure the Re-
mote function of the Procross 8.0 DS is activated. To activate the remote function,
press the Remote controle button [12].
· Press the Slope button [2] for approx. 2 seconds. The display shows Slope per-
centage of the X-axis [A] and the Y-axis [B] (both 0% by activating).
The value of the X-axis [A] blinks, this means that the slope can be set on this
axis. Set the desired slope percentage using the UP [8] or DOWN [11] button.
Press the LEFT [9] or RIGHT button [10] to go to the Y-axis. The Y-axis value [B]
starts blinking. Set the desired slope percentage using the UP [8] or DOWN [11]
button.
When the slope percentages for X- and Y-axis are set on the remote control
confirm this by pressing the TILT button [3]. This will send the choosen slope to
the laser.
·
before setting the laser in this sloPe it starts levelling first.
during this levelling, the X and y from the sloPe Percentage indicators [A]
[B] on the disPlay of the remote control and the red level/sloPe led [d] will
blink.
after the motorised Pendulum is levelled, it will set the sloPe you’ve set on
the remote control. when the sloPe is set, the red level/sloPe led [d] will stoP
blinking.
(in some cases this oPeration can take uP to aPProX. 60 seconds)
· To set a new slope, press the LEFT [9] or RIGHT button [10] to enter the setting
again and repeat the steps above.
· To turn off the digital slope, press the slope button [2] for approx. 2 seconds.
The laser will start levelling itself.
