25.
WARNING: Do not use this heater in small rooms when they are occupied by persons
not capable of leaving the room on their own, unless constant supervision is
provided.
Before use
1. Remove the heater carefully from the packaging.
2. Check all the parts are present.
3. Read and understand the user manual.
Installation
The panel heaters can be wall-mounted or floor standing using the feet and castors
supplied.
Mounting the Feet (Fig. 2)
Remove the heater and all the accessories from the carton.
1. Turn the heater upside down.
2. Match the three feet holes with the pre-drilled holes at the bottom of the heater.
3. Use the 6 x screws provided to secure the two feet to the heater.
4. Turn the heater the right way up.
Wall Mounting (Fig. 3-6)
Note: Before drilling, ensure that there are no wires or pipes in the wall to prevent
electric shock or damage to plumbing.
1.
Drill two holes with a diameter of 8mm and depth of 40mm on the wall, Ensure the
distance of two holes are required. (200mm for 400W; 335mm for 1000W; 405mm for
1500W;
515mm for 2000W. )
2. Then insert the plastic anchors supplied within into the drilled holes.
3. U
se a screwdriver to tighten the screws supplied into the plastic anchors, leave the
head of the screw protruding from the hole by 6mm.
Fig. 2
