OPERATION
Receiving a Phone Call
Handset
1. When your phone rings, pick up the handset and use it like any basic
telephone.
2. Hang up the handset to release the telephone line when conversation is
completed.
Dialing a Call
Pick up the phone and wait for a dial tone, then press the keys for the number
you want to dial.
KEY FEATURE
Last Number Redial
Your PHONE remembers the last number dialed. If the number you dial is busy or
not being answered, hang up. To redial the last number automatically, press the
REDIAL button. NOTE: You can redial the same telephone number as many times
as required. However, once you dial another number, the previous number is
erased.
Ringer OFF / LO / HI
Your phone provides a ringer adjustment of High, Low or Off, when you don‘t want
to be disturbed, slide the switch to the off position. Now you can still make a
outgoing calls without being disturbed by incoming calls.
Flash
The FLASH button can be used to retrieve a new dial tone after ending a call. The
FLASH button is also a useful feature for special telephone services such as call
waiting and three party calling. Press briefly, release and perform the custom call
procedure.
NOTE : Call waiting is a service of your local telephone company.
Receiver Volume Control
On the front edge of your telephone you will find a slide volume control. This
control may be used to adjust the volume of received speech. With the control set
towards the right hand side of the phone, the received volume will be at its
maximum. With the control set to the left side, it will be at its minimum.
MEMORY FEATURE
To Program
Your PHONE is equipped with M1 & 911 memory key and ten 2 touch memory
keys for programming your most frequently dialed telephone numbers. You can
store up to 16 digits in the priority key button or in each of the numeric key button
(0 through 9), by following the steps outlined below:
1. Slide the
Normal / One touch Switch
to NORMAL
position.
2. Place the volume control to the lowest setting (furthest left)
