850 REV04 REV DATE: 09/03/2014
Page
8
of
16
4.0 Prism Back Installation Instructions
5.
To Install the Prism Back onto the back mounting plates please refer to the
Instructions and diagram (see Fig. 5 below).
Step 1:
Insert the upper mounting plate into hooked slot on the top of
the back mounting plates.
Step 2:
Ensure that the LT detent latch is in the closed position.
Step 3:
With the upper pins in place, snap lower pins into the latch mechanism
at the bottom of the back mounting plates.
6.
In order to install the longer Mounting Pins, first remove the outer cover
from the back.
! PLEASE NOTE
Our Standard Prism Back can be adjusted to accommodate wheelchair seat frame sizes up to 2”
wider than the actual back width. Each Prism Back is shipped with the standard mounting pins
installed. A set of longer pins for 1” wider and 2” wider seat frames can be purchased separately.
UPPER MOUNTING PIN
LOWER MOUNTING PIN
