USER GUIDE |
USB BACKUP HSM
Page
18
of 31
[7] DEVICE RESET
There may be circumstances (forgotten PIN, redeployment, return to factory default settings) when you need
to completely reset the device. The complete reset feature will perform a crypto-erase on the device,
generate a new encryption key, delete all users and formatting, and will return all of the settings to factory
default.
To perform a complete reset of the device, do the following:
1. Press and hold
+
+ 2 together for ten seconds. The
red
and
blue
LEDs will blink alternately.
2. The
green
and
red
LEDs will glow solidly for several seconds, followed by the
green
LED glowing solidly
for several seconds, followed finally by the
green
and
blue
LEDs glowing solidly which indicates that the
reset is complete.
3. A new Admin PIN will need to be entered, and the device will need to be reformatted before it can be
used again.
l
For setting up a new Admin PIN, see the section on "Setting up the Admin PIN" on page 5.
l
For formatting the device, see the section on "Formatting the USB Backup HSM" on page 7.
