R31 Hack
Oops. It’ll be fixed on V1.1 of the PCB, but for now this needs to be hacked in. It’s simple.
Leave some of the leg of R19 above the board when mounting. When everything else is assembled
simple place R31 from the exposed leg of R19 to pin 1 of the SPD pot, above D3.
Adjusting the trimmers
GAIN - turn all the controls down to zero. Adjust the trimmer until your engaged signal is the same
level as your bypassed signal, or louder if you want some boost.
T1 adjusts the overall modulation depth. Tweak to taste. There’s no right or wrong.
Summary of Contents for AlluringEcho
Page 4: ......