The best way to get the pots lined up
is to first solder one pin of each.
Once they’re tacked in place adjust
them so they’re straight and check to
see if the heights line up. If not, melt
that soldered joint and adjust. Once
you’re happy all the pots are aligned
you can solder in the other legs.
Make sure you don’t push the pot
pins all the way into the PCB.
There’s not a lot of clearance
on the bottom of the dual gang,
so it has to sit a little way up
from the PCB.
Summary of Contents for Klone V4
Page 7: ...Wire it up switching board ...
Page 8: ...Wire it up true bypass ...
