FuzzDog Shin-Ei FY2 Companion Fuzz Quick Start Manual Download

Page: 7 / 7

Drilling template

Hammond 1590B
60 x 111 x 31mm

Recommended drill sizes:

Pots

7mm

Jacks

10mm

Footswitch

12mm

DC Socket

12mm

This template is a rough guide only. You should ensure correct marking of your

enclosure before drilling. You use this template at your own risk.

Pedal Parts Ltd can accept no responsibility for incorrect drilling of enclosures.

PedalParts.co.uk

It’s a good idea to drill

the holes for the pots

8mm to give yourself

some wiggle room unless

you’re a drill ninja
Centre pot hole is for the

optional scoop control.

32mm

27mm

Summary of Contents for Shin-Ei FY2 Companion Fuzz

Page 1: ...ionFuzz A lot of nasty ass fuzz with a bonus post boost Contents of this document are 2015 Pedal Parts Ltd No reproduction permitted without the express written permission of Pedal Parts Ltd All rights reserved ...

Page 2: ...0n C8 47n C9 10u C10 10u C11 100u Q1 2 Low gain silicon NPN 2N3904 2N2222 etc Q3 2N3904 VOL 50KB FUZZ 50KB See notes overleaf about pads J1 and J2 Components shown in blue on the schematic are the LPB post boost circuit To make it without the boost leave out the blue components and place a jumper wire across the two pads marked in blue above PCB Layout 2015 Pedal Parts Ltd ...

Page 7: ... ensure correct marking of your enclosure before drilling You use this template at your own risk Pedal Parts Ltd can accept no responsibility for incorrect drilling of enclosures PedalParts co uk It s a good idea to drill the holes for the pots 8mm to give yourself some wiggle room unless you re a drill ninja Centre pot hole is for the optional scoop control 32mm 27mm ...