R1 can be your prefered
value for the LED current
limiting resistor - we supply
2K2 with the kits. The short
leg (-) of the LED goes into
the square pad.
You don’t have to connect a
battery snap to pads B+ and
B- unless you intend to use
one. If you do, the battery
will only be connected when
a jack is inserted into the
input socket.
2-way screw
terminal
connector,
5mm pitch
1/4” jack socket,
PCB-mount Stereo
(output jack can be mono)
2.1mm DC socket,
PCB-mount*
3PDT Footswitch or
3PDT Toggle Switch
SIL sockets
4 or 6 way
TESTING YOUR CIRCUIT...
Direct Connect
Simply insert your 4- or 6-way ribbon connector into the sockets. More often than not it’ll be 4-way - this
should be inserted into the middle four sockets, ignoring the outer two.
Ensure you have the connections the right way around, i.e. IN to IN, V to V, etc. With all FuzzDog kits the
pots will be upover if aligned correctly, just like they would be on a boxed-up circuit.
Wired
Simply connect your four power and signal wires to the appropriate terminal.
