Section 40
00-02-0893
2014-07-18
-
4 -
Operating
Display Functions: Main Menu
Figure 1.0 shows the Main Menu screen seen after power is applied. For approximately 8
seconds the screen displays “Initializing…” During this time, the display is establishing
communications with the controller and its initializing parameters. The button labels along the
left side show from top to bottom:
Operator Page
:
This button changes the screen to the first page of the operation page section.
Off-Line Diag
:
This button takes the user to the passcode screen and then to the off-line diagnostic testing
page. The system must be in the Standby Mode for this button to be active. For example, if the
engine is running, this button will not be active.
System Setup
:
This button takes the user to the passcode screen and then to the setup menu. For details on
what is available please refer to the programming section of this manual set.
Help Menu
: This button takes the user to a page with a menu list of general help topics.
Figure 1.0 Main Menu Screen
Also included on the Main Menu page is the day/date and clock. Here the F/W (firmware
version) is shown as 4.07, although your firmware version may be different. The brown color of
the version parameter indicates that it is read from the controller.
The Display Rel (release) date is the date the program file for the display was released. As
changes are made to the display program in the future, this date will be reset to the date of
release.
