OPERATION
To operate:
Place the G002GKA on a firm flat surface. Ensure that the bubble outlet (at the front) is not
obstructed. Alternatively, the appliance may be suspended from the attached hanging bracket.
The unit must be suspended in a horizontal position and not tilted. Plug the power supply into a
13 Amp mains socket and attached to lead to the unit via the 12V socket on the rear of the unit.
Mode: Always on
Move the switch on the rear panel to position I. The unit should now continually function until
switched off
Remote Control Function:
Move the switch on the rear panel to position II
Using the remote control use the on/off buttons to switch the unit on or off.
To Switch Off:
Move the switch to (0) Position
To fill the tank:
Disconnect from its power supply.
Fill the tank (at the front) with Venü Benchmark Bubble Fluid (catalogue numbers: FL801 for a 1
litre bottle or FL805 for a 5 litre bottle) taking care not to allow any fluid into the rear of the unit.
To empty the tank:
Disconnect from the power supply
Use a funnel (not provided) and tip the bubble machine forwards and sideways so that the
unused bubble fluid flows out of the front corner of the tank taking care not to allow any fluid to
run into the back of the unit. Return the unused fluid to the bottle. Dry the tank with a cloth or
paper towel before moving or storing away.
MAINTENANCE
Cleaning:
Clean the outside of the unit with a soft damp cloth, with a drop of washing-up liquid.
To clean the appliance:
Empty out any residual bubble fluid.
Rinse the tank with water.
If the power supply is damaged, it must be replaced by a like for like product authorised by the
manufacturer.
FAULT-FINDING
Unit Does Not Function:
1) Check the power supply is plugged into a wal socket and the socket is switched on.
2) Make sure the lead is plugged into the socket in the back of the unit and the switch is in the
correct setting.
3) If using the remote control follow the above advice but also check that there is a battery in the
remote control.
