OPERATION
Place the G002GSS on a firm flat surface. Ensure that the snow outlet cone (at the front) is not
obstructed and is free to move.
To fill the tank:
The unit should be disconnected from the mains supply.
• Unscrew the lid, and fill with Snow Fluid
• Replace the lid
• Push the filter tube to the bottom of the tank.
• Plug the mains lead into a 13 Amp mains socket.
• If connecting via an extension lead, make sure that the lead is rated at 13 Amps or more, and
that it is fully unwound.
Turn the machine on via the switch on the rear. The switch will illuminate red. The red LED on
the controller will also illuminate. Depress the red button on the wired controller, a green LED will
illuminate on the controller. Turn the knob on the controller to control the speed of the fan. The
snow machine will continue to produce ‘snow’ until switched off via the remote. If the unit runs
out of fluid turn off the machine at the remote switch immediately. Running the machine with no
fluid risks damaging or seizing the pump and will invalidate any warranty.
This unit is also supplied with a wireless remote control which operates in place of the red button
on the wired remote. To use first set the desired fan speed using the knob on the wired remote
control then ensure the red button is in the off position. Press the on button on the remote to
operate. The fan and pump will then operate. To switch off press the OFF button.
The unit is supplied with 2 decorative Led’s which add to the snow effect. The LED’s will turn on
when the pump is set above a set level and the unit is switched on.
MAINTENANCE
Clean the outside of the unit with a soft damp cloth, with a drop of washing up liquid.
To clean the machine internally:
• Remove the lid from the tank
• Empty out any excess fluid
• Rinse the tank with a 20% solution of white vinegar and distilled water. This will remove any
lime deposits and kill bacteria.
After forty hours’ of use, and before long-term storage clean the tank with the vinegar solution
and then operate the machine with just distilled water (no vinegar) to remove any snow fluid from
the pump and tubes.
• Connect the brown wire to the terminal labelled “L”.
• Connect the blue wire to the terminal labelled “N”.
• Connect the green-yellow wire to the terminal
labelled with the earth symbol.
• Make sure that the cord-grip is positioned correctly
(over the outer sheath of the cable) and is fully
tightened.
Page 3
If the mains lead is damaged, it must be replaced by the manufacturer or an authorised service
centre. If the mains plug needs to be replaced, proceed as follows:
