FXO H.323 Gateway User Manual
Document Ver.: 118a
Release Sep, 2004
36
Master : Follow the result from the MasterSlaveDetermination.
Caller : Follow the caller side.
Reverse(FXS) – Enable or disable the Reverse signal generation function.
Support the FXS type only
.
Local Generate Ring Back Tone(FXS) – To enable or disable the ring back
tone generation from the local side.
Support the FXS type only
.
Gateway Prefix – To keep or drop the prefix number of this gateway. This
only support the Gateway type in the GK routed mode. Please get more
detail useful as below:
The gateway could keep or drop the prefix number if the call is coming from the
ip side and bring the prefix number of this gateway. The usage of this
command is about the one-stage-dialing function. Of course it must work with
the Routing table.
Source
Gateway Prefix
Receive
Transfer
10012345
Keep
10012345
10012345
10012345
Drop
10012345
12345
If the incoming call (From IP side) with the number is 10012345, and the prefix
number of the destination gateway is 100. The gateway will receive 10012345.
But the number it transfer will be 10012345 (Gateway Prefix Keep). The
transfer number will be 12345 if the Gateway Prefix function is enabled.
End of Dial – To enable or disable the end of dial function. This function
key will be the digit “#”.
Dial to PSTN side(162) – This function only support the IAD 162 unit.
Ring Time(FXO) – It for the ring detection from the PSTN. The ring
detection will be failed if users configure it too long.
Ring Before Answer(FXO) – This will help the users to answer the calls
from PSTN into this gateway quickly. The call will be connected by one
time ring if users configure this for 1. From 1 to 10.
Delay to add DTMF(FXO) – The timer for the DTMF signal sending if the
calls are from the IP to PSTN side. It could only support the
It’s only for the special requirement. Please contact with your vendor before
you configure this.
