-
10
-
1.4 The maximum speed of the treadmill will be limited to
4MPH
when the dashboard
deflected from a horizontal direction to an arbitrary direction by more than
60 degrees
.
(2) Function of the Remote Control
2.1 "Start/Stop":
(1) In standby or countdown mode: Pressing "start/stop" button to start the machine.
Please note that the default speed is 0.5 MPH.
(2) Choose the preset program: Pressing "start/stop" to start the machine and thespeed
will changes according to the preset speed.
(3) In running state: Pressing "start/stop", then the treadmill will stop slowly and back to
standby state.
2.2 "+"/"-" button is to adjust speed. Keep pressing "+" or "-" button over 0.5 seconds,
the speed will keep increasing or decreasing. The speed will change by 0.1 MPH
2.3 "M":
①
In standby mode: it can switch from different mode, including Time, Distance
and Calories.
②
In running mode: press "M" button will switch display mode between
cyclic display mode and single display mode.
2.4 "P": There are P01~P12, totally 12 preset programs you can choose when in standby
mode.
2.5 Press the
button to mute the treadmill (no sound “Bi”); press it again to resume the
beep sound.
2.6 After using, press
button, the treadmill will stop slowly and it will retain its data
until power off. It will resume the previous speed when it starts again.
2.7
：
Press the
button, the data will be reset to its default data. It only works when
the treadmill is in standby mode.
※
REMARK: Any valid pressing, the treadmill will make a sound “Bi”.
(3) About the Remote Control
3.1 Pull out the insulating sheet, you can use the remote control directly.
3.2 The remote control can directly control the treadmill.
3.3 If you have purchased multiple treadmills, in order to prevent the treadmills from
interfering with each other, please perform the following operations to match:
3.3.1Turn on the one of treadmills.
3.3.2 Simultaneously press the
and
buttons together on the remote control for 5
seconds. The display screen will flash, and the treadmill will match the remote control.
3.3.3 Please note: After matching the remote control, if remote control is replaced,
