background image

First time use:

1.  use the slider 

 

to open the FC-55

2.  remove the battery compartment cover

3.  activate the button cell by pulling out the insu-

lating strip from the FC-55

4.  install a 1.5V alkaline battery, paying attention 

to the polarity (+ and -)

Replacing the button cell:

1.   slide the white tab to the right until it releases 

from the left 

side

2.   remove this tab 

and replace the 

button cell (the 

+ upward)

3.   replace the tab 

to the right in 

the opening, 

push it down 

and slide it to 

the left until it secures the battery again

4.   now press 1x the 

RESET

 button and set the 

clock and alarm times again

Don’t discard exhausted batteries as normal 

domestic waste, but bring them to a collec-

tion point for small chemical waste.

Setup:

clock:

1.  unlock the buttons by sliding the 

 switch to 

the left

2.  press and hold the   button for 2 seconds until 

the hour display starts flashing

3.  rotate the white knurled ring to set the hours

4.  briefly press the 

 button; the minute display 

starts flashing

5.  rotate the white knurled ring to set the minutes

6.  briefly press the 

 button to save the time

alarm times:

1.  unlock the buttons by sliding the 

 switch to 

the left

2.   press and hold the 

 button for 2 seconds 

until alarm time 

1

 starts flashing

3.  rotate the white knurled ring to set the alarm 

time for the first medication of the day; the 

alarm time is set in increments of half an hour

4.  briefly press the 

 button; alarm time 

2

 

starts flashing

5.  repeat instructions 3 and 4 for alarm times 

2

3

4

 and 

5

 (*)

6.  briefly press the 

 button to save the alarm 

times

*: If less than 5 alarm times are required, continue 

rotating the ring until -:-- appears in the display; this 

alarm time is now disabled

to change the alarm times:

1.  unlock the buttons by sliding the 

 switch to 

the left

2.   press and hold the 

 button for 2 seconds 

until alarm time 

1

 starts flashing

3.  repeatedly press the 

 button until the alarm 

time you’d like to change starts flashing

4.  rotate the white knurled ring to set the new 

alarm time (*)

5.  repeatedly press the 

 button to save the new 

alarm time(s)

*: If you want to delete an alarm time completely, 

continue rotating the ring until the display shows 

-:--; this alarm time is now disabled

FC-55

Electronic pill box with alarm..

Introduction:

The Fysic FC-55 pill box allows you to store med-

icine for 5 daily moments. You can program up to 

5 times at which the alarm must sound while the 

display indicates which medicine must be taken.

This schedule is repeated daily until you program 

different times.

The FC-55 pill compartments are only suitable for 

dry medicine (pills, capsules, etc.), not for liquid or 

ointments.

Power supply:

The FC-55 is powered by 2 batteries: One CR2025 

lithium button cell for the clock and timer function. 

This battery is already installed by the factory, but 

can only be used after removing the insulating 

strip.

The other is a 1.5V battery (size AAA) for the 

sound and vibration alarm and for the display 

lighting. This battery is not included. Please use an 

alkaline battery for this, not a rechargeable one.

1

2

3

1

2

4

Reviews: