b、Washer Welding
3 、 Operation
Page.12
Connect washer adaptor
with
welding gun and tighten,
Install washer.
Remark:
1 、 Setting amperage too high or time too long can cause workpiece surface (vehicle body)damage .
Please weld other workpieces for practice before actual operations.
2 、 Setting correct amperage and time according to the workpiece thickness.
3 、 Continuing another operation is applicable after these procedures finished .if not, please
shut off the main power supply and switch off the unit.
Set correct time.
Select welding function
Connect negative outside wire
to a clean,paint-free location
on metal workpiece,as close to
welding area as possible.
Approximately a 90°angle to the
dent.Put on pressure and press
trigger.
Remove welding gun.Hook the washer with
pull hammer.Slide the hammer to opposite
direction to pull out the dent .
(Position A orB is recommend).
Set correct power
Summary of Contents for GI12117
Page 1: ...USER MANUAL GI12117 ...