c、Triangle Washer Welding
3 、 Operation
Page.13
Connect triangel washer
pull hammer with welding gun.
Slide the hammer to opposite
direction to pull the dent
Set correct time.
Approximately a 90° angle to
the dent,put on pressure
and press trigger.
Remark:
1 、 Setting amperage too high or time too long can cause workpiece surface (vehicle body)damage .
Please weld other workpieces for practice before actual operations.
2 、 Setting correct amperage and time according to the workpiece thickness
3.Triangle washer welding can replace washer welding.It can draw out the concavity directly
after welded.
4 、 Continuing another operation is applicable after these procedures finished .If not, please
shut off the main power supply and switch off the unit.
Select welding function
Connect negative outside wire
to a clean,paint-free location
on metal workpiece,as close to
welding area as possible.
(Position A is recommend).
Set correct power
Summary of Contents for GI12117
Page 1: ...USER MANUAL GI12117 ...
