FEATURES AND OPERATIONS
8
Deactivate the Starter Kill and Alarm (Permanently VALET Mode)
The valet mode allows you to deactivate alarm and starter kill and allows anyone to start and drive the vehicle with the key in the ignition. In valet mode, lock,
unlock and remote trunk release are still functional.
Remote car starter and the alarm are not functional. This may be pratical in the following cases :
You have lost the remote.
The remote’s battery is empty.
You leave your vehicle to be serviced
You leave your vehicle to a valet service.
To enable the valet mode, there are 2 procedures:
Procedure A
1. Turn the ignition key to ON position (engine is not running). You have to perform the step #2 within 15 seconds. If 15 seconds is
expired, turn the ignition key OFF and redo this operation.
2.
Depress 4 times the brake pedal, within 15 seconds after the ignition key is turned to ON
. The LED lights on the antenna will stay ON confirming
that the system is in permanently valet mode. (2 chirps / 2 flashes)
Procedure B
1. Turn the ignition key to ON position (engine is not running). You have to perform the step #2 within 15 seconds. If 15 seconds is
expired, turn the ignition key OFF and redo this operation.
2.
Press and hold the button found on the antenna for 3 seconds
. The LED lights on the antenna will stay ON confirming that the
system is in permanently valet mode. (2 chirps / 2 flashes)
Note :
In the permanently valet mode, the starter kill function is deactivated . You cannot start your vehicle by remote. If you press on start button , the parking lights
will flash 2 times and the engine will not start.
To cancel the permanently valet mode, repeat steps 1 and 2. This time, the confirmation will be 1 chirp, 1
flash and the LED lights will turn off.
