16
e)
1 data byte with the output channel number for the Program Change 2 (range 1-16)
f)
1 data byte with the output channel number for the Program Change 3 (range 1-16)
g)
1 data byte with the output channel number for the Control Change (range 1-16)
h)
1 data byte with the information about the memory access lock state
(1 - "UnP", 2 - "-20", 3 – "-40", 4 - "-60", 5 - "-80", 6 - "All")
i)
1 data byte with the controller’s number for Control Change
(range 1-128 interpreted as 0-127)
j)
1 byte with the information about the MIDI output mode (0 – out , 1 - thru)
k)
4 reserved data bytes
Next 100 frames contains the information about the presets:
a)
1 byte with the information about the AUXILIARY OUTPUTs state according to the scheme
below
A1 - A8 – AUXILIARY 1 - AUXILIARY 8
b)
1 byte with the information about the SWITCH OUTPUTs state according to the scheme
below
S1 – S4 - SWITCH 1 – SWITCH 4, X – reserved
c)
1 byte with the information about the LOOPs state according to the scheme below
L1 – L6 - LOOP1 – LOOP6, B – BUFFER, X - reserved
d)
1 byte with Program Change 1 value (range 1 – 128, 0 = not sent)
e)
1 byte with Program Change 2 value (range 1 – 128, 0 = not sent)
f)
1 byte with Program Change 3 value (range 1 – 128, 0 = not sent)
g)
1 byte with controller’s Control Change command value
(range 1 – 128 interpreted as 0 =not sent and 0 – 127)
h)
9 reserved bytes
Next 27 frames contains reserved data bytes.
7)
F7 – Sysex end byte
MIDI OUTPUT "Soft Thru" mode
Controller’s output can be set on so-called Soft Thru mode. On this mode data received by MIDI input are
sent in unchanged state by output. On this mode the controller doesn’t send neither commands
programmed within the presets’ frame nor the special message dump memory.
Summary of Contents for MIDI Guitar Controller
