www.g-lites.com
11
Warning 5:
When the lamp is blackening, cracking, deformed or damaged, let the lamp cool
down 15 minutes. If replacement of lamp is needed, read the user manual
forwarded by the manufacturer.
Warning 6:
The inside temperature is much higher under normal working conditions. Do not
touch the moving head with bare fingers. Negligence or misuse of directions in
manual may lead to damage.
Advertisement:
Use the OSRAM or PHILIPS lamp is the first choice. (The average lift time of the
OSRAM and PHILLIPS is 700 hours; the average lift time of other brand is 70-
100 hours).
4. Power Supply & Control
4.1 Power Supply Connection and Control
Use a professional plug to connect the moving head and main power supply. Pay
attention to the voltage, frequency the same as mentioned on the moving head;
suggest each fixture has an independent switch of the power supply so that it can
be turned on or off.
4.2 Signal connection
Please use the round 3-pin XLR plugs & sockets offered by manufacture to
connect the first moving head's output to the second moving head's input and
connect the second moving head's output to the third moving head's input and in
the same way for the rest as shown below.
Summary of Contents for 600SZ
