4
Adjust the center of light beam: the light beam adjust well or not is the hinge of the
light effect. After finished the lamp installation, please do not stand in front of the
lamp when the front cover was open.
Switch on power the lamp will light up. And then make the light faces to a plane goal
and check the light center whether is right or not. If need to adjust, you can turn the
screw near the light beam to right or left to make the center of light beam at the right
station.
Adjustment of facula number: there has turner at the back cover of light. You can
adjust the focus by turning it to right or left to meet your inquiry. Then the focus of
facula to one parallel light beam, the light up distance is most far. When you use it as
special light-set, you can adjust the focus as your inquiry. Pay more attention to that
there has the black center of the light beam if your facula is too large.
Light source is high voltage xenon lamp: Do not touch the ball part during the
installation, to keep clean the ball and increase the light effect and life-span. Lamp
must cool by strong wind during working. Must pay attention to the back fan whether
works well or not always.
Clean all optics lens and reflector at regular to increase the effect. Cleaning times
according to the operate frequency and usage situation. We suggest to clean the
outside systems per 20 days a time and inside optics lens per 60 days. To keep
luminous flux rate through clean the lamp with soft cloth or cotton stick dipped
alcohol to wipe the mirrors.
This light has the automatic scan system. If the lamp was working, and you want
automatic scan and strengthen the light, it just switch on the motor-head the power
console then the light will scan about 120° in the horizontal direction 3 times per
minute.
This light has 5 power switches, open one add 1000w, if open all the switches. That
it’s the total power of the lamp.
This lamp is automatic touch off, it will light on when connect power, if it doesn’t
happen, please check as following:
Test the voltage at the two sides of the lamp bulb first. If there has no voltage or
voltage not stable, it means that the power board has problems. If there has stable
current up to 100V above in the two sides of the lamp bulb and trigger make fir all
the time. It means that the lamp bulb maybe has problems. If the trigger does not
Summary of Contents for STAR SEARCH 4000
Page 1: ......
