Page 9
Trackside R/C
Transmitter Commands
Op Mode 1 (Single Track, Default)
Single Key Function
2
nd
Key function
Examples:
Press “Stop” key once to Stop.
Press the “2
nd
Key”, followed by the
“Stop” key to Toggle Rate.
Forward
- Press momentarily to change direction to forward.
(see note below)
Reverse
- Press momentarily to change direction to reverse.
Faster
- Press momentarily to bump speed up. Hold down to
ramp speed up.
Slower
- Press momentarily to bump speed down. Hold down to ramp speed down.
Stop
- Press momentarily or hold to perform a Quick Stop while running.
2nd
- Press momentarily, followed by another key to perform the secondary function.
2nd, Forward
- not assigned
2nd, Reverse
- not assigned
2nd, Faster
- Recall the saved running speed.
2nd, Slower
- Save the current running speed.
2nd, Stop
- Toggle the momentum rate; either fast for switching or slow per User Parameter 0 for prototypical
speed changes.
Throttle Programming -
Enter Throttle Programming mode by holding down the
2nd, Slower, and Stop buttons
until the LED in-
side the Trackside base station starts flashing.
Use Faster/Slower Buttons to control speed (0 to 100%)
Press Forward to set the Max Speed (must be greater than 50%)
Press Reverse to set the Min Speed (must be less than 50%)
Press 2nd to reset throttle to full range (0 to 100%)
Press Stop button to exit and save changes at any time. LED will stop flashing.
Learn TX
- Press the Learn button on the circuit board inside the Trackside box. LED will start flashing. Then
press Stop on the transmitter. LED will stop flashing.
Note: Forward and Reverse won’t function while loco is in motion. Direction of locomotive travel is relative to
the way you place your loco on the track. Place your locomotive on the track in the direction it will normally
travel. When the Trackside is first powered up, “Forward” will be selected. If your loco runs backwards, you can
either reverse the wires to the track, or change User Parameter 5.
Faster
Recall Speed
Stop
Toggle Rate
2nd
-------
RailBoss 4 Transmitter
Forward
Reverse
Slower
Save Speed
