p.31
Configuring with Disk Utility
G DOCK
™
ev
with Thunderbolt™
Supported Media Configurations
The Evolution Series G-DOCK ev is user configurable and can be used in:
• JBOD (Just a Bunch Of Drives) configuration, or
• RAID 0 (Performance) stripped across two G-DRIVE ev Hard drives, or
• RAID 1 (Protected) in which data is mirrored from one drive to the other.
These configurations are initiated and managed by utilizing the Mac OS Disk Utility.
G-DOCK ev is pre-configured during manufacturing to operate in a JBOD configuration.
The sections of this user guide,
Set Up as RAID 0
and
Set Up as RAID 1
, give you the
general steps for configuring your G-DOCK ev. For additional information, please visit
www.g-technology.com/support
; or Apple’s support site RAID User Guide; or the Disk
Utility Help Center in the Disk Utility application.
Set Up as JBOD
G-DOCK ev with Thunderbolt has been configured at the factory in a Just a
Bunch of Drives (JBOD) configuration. This configuration supports both ev
hard drive modules as separate volumes on your system.
About RAID Sets
A Redundant Array of Independent Disks (RAID) lets you combine multiple disks so they
work as one disk. Depending on how you combine the disks, the RAID set can protect
your data against hardware failure, speed up access to your data, or increase your stor-
age capacity.
raid configure
Summary of Contents for G DOCK ev
