5-8
G-Tek Corporation
Installation
3.
When line power is poorly regulated and / or subject to voltage surges or transients,
consideration should be given to the use of a line conditioning/transient suppressing line
power regulator. Process control motors, valves, relays and heaters should not be connected
to the same power lines that are used for instrumentation.
4.
All local electrical codes of practice must be followed when installing any instrumentation.
5.1.2
Mains Supply Connection
The connection for Mains supply is shown in figure-9. As per figure one end of the adaptor connected
to mains connector else other option for power supply through 2pin relimate female. Ensure that the
end of adaptor/ connector is fully inserted into the mains connector and no loose/poor connection.
Figure 4 Mains supply connection
5.1.3
Alert Inputs
Total 5 alert inputs are available. For connection, Pitch of male relimate is 2.54 mm and 10pin Stranded
wire recommended for female relimate. Remaining two pins are NC. Alert priority 5 input is the highest
priority input and alert priority input 1 is the lowest priority input.
What type of alert inputs?
Mains
Connector3.5mm
jack
MKDSN
Connector
9-30V DC 1-Amp Adaptor
Alert Priority 5 Input
Alert Priority 4 Input
Alert Priority 1 Input
Alert Priority 2 Input
Alert Priority 3 Input
Figure 5 Alert Inputs
