GT-BH18External Booster Heater
Page 4
1. POWER CONNECTION:
Warning: All connection of electricity and grounding must comply with any applicable
ordinance of the national or local electrical law.
Warning: Shut off power supply, hoist caution sign nearby, to alert anyone
NOT
to
power on. Please read carefully the electrical wiring diagram as shown on the
machine case, properly connect power cables with the designated terminals.
Warning: An independent isolator must be used for this booster heater.
2.
WATER CONNECTION:
Warning: Water pipe connection must comply with relative local hygiene safety
ordinances and plumbing code.
Incoming water inlet: G3/4”
Incoming Pressure: 1-6 kg/cm2
Outgoing water inlet: G3/4”
Connect the water from the Pressure Relief Valve to drain
INITIAL OPERATION
1. Before starting the operation, make sure the water in the wash tank is drained off and
drain valve is open and all manual incoming water valves are turned on. Then switch on
the power of the dish washer to fill up the tank.
2. When the tank is full, run a few empty racks and adjust the incoming pressure of the
booster heat to 1-6 kg/cm2.
Warning: Shut off power supply before the heater is completely filled up with water.
Failing to do so will seriously damage the heater.
3. Observe the temperature if it is in the range of 82-90
℃
after running for 10 minutes.
4. Check if there is any leakage and fix it immediately.
