Page. 26
LM P RS485 Data Logger
6.7
CHPS
(C
HANGE
P
ASSWORD
)
➢
User can set password to enter in main menu from using change password feature.
➢
If PSEN Option is enabled by user, then user can change password by following the
steps displayed in figure 22.
➢
User can set the 3-digit password using this function.
➢
Note that, if PSEN Option is disabled by user, then this function is not used.
6.8
**BSTS
(B
ATCH START
/
STOP
)
➢
Every time new batch is started, device memory will be cleared first (The clear string
will blink for few seconds), then the new data is stored in memory. To start the
batch, follow the procedure shown below by pressing the appropriate buttons given
on the front panel of the Device.
➢
To set the Batch start/stop, follow the procedure shown in figure 23 and 24.
Figure 23 BSTS (Batch start)
After a few seconds the display
parameter will automatically appeared
strt
bsts
conf
0
Save
clr
Figure 22 CHPS (Change Password)
To
change
the
cursor
position, press down key.
To
increment
the
digit
number, press up key.
chps
pass
0
0000
SAvE
Summary of Contents for LM Pro 63 Series
Page 1: ......