Page. 23
LM P RS485 Data Logger
6.3.6
OFST (offset)
➢
Offset is the amount of deviation that occurs in the output due to calibration errors
of the sensor.
➢
Thus, if there is a deviation in the output compared to the expected output, offset
value should be set appropriately to null the effect of deviation.
➢
To set the offset, follow the procedure shown in figure 17.
6.3.7
MUL (Multiplier)
➢
Multiplier is a function given for the user flexibility. If the user wants to observe the
output in the range other than the actual output range, multiplier value should be
set.
➢
To set the Multiplier, follow the procedure shown in figure 18.
Figure 17 OFST (Offset)
Figure 18 MUL (Multiplier)
Press up key and down
key to change the value
0
Ofst
Save
0
Press up key and down
key to change the value
1.000
mul
Save
0
Summary of Contents for LM Pro 63 Series
Page 1: ......
