E006
Page 14
In addition to above functionality, keys are used for following functions:
Device Activation
➢
LM-XS Pro E006 data logger is dispatched in deep sleep mode.
➢
Please connect the sensor before activating the device.
To activate the LM-XS PRO data
logger, press
“
Up
”
key
for about 10 seconds.
➢
Once the device is activated, all segments of display will turn ON for 5 seconds followed by
calendar format selection and set RTC of the data logger.
➢
If RTC is not set, the data logger will go in deep sleep mode again within 1 minute.
➢
After RTC is set, device batch will start after
10 minutes
of device activation. During this
delay time, sand clock symbol will be visible and
“STP” LED will be flashing
. Once the
recording of data is started,
“
STP
” LED
turns off
and “RUN” LED starts flashing and
“REC”
message is seen on display.
Min/Max
➢
Press
“
Function
”
and
“
Up
”
key at the same time for 1 sec, the display will start showing
Min /Max temperature data of the current day in order.
Current Data
➢
Press
any key
for 1 sec, the display will show current temperature data.
Alarm Acknowledge
➢
Press
“
Function
”
and
“
Enter
”
key
simultaneously to acknowledge the alarm high/low
condition. The buzzer will be deactivated for prefixed 1 hour time Delay.
➢
After 1 hour acknowledgement delay, if alarm high/low condition persist, buzzer will
activate again.
