1
2
3
4
5
1
2
1
2
PleASe CleAn THe PARTS THAT ConTACT FooD THoRouGHly BeFoRe eACH uSe
oF THIS APPlIAnCe.
Instructions
Start / Stop button:
when you press this button the appliance starts to work. It automatically stops after 20 minutes. If
you need to stop in the midway, just press this button again.
Reversal button:
if the appliance stops, press the reverse button. It is necessary to hold this button at least 3 se-
conds.
Sliding stall:
Adjusting soft and hard food materials. If processing soft materials move the sliding stall to soft
and vice versa. If you need to dismantle feeding tube from the main body, please toggle sliding
stall to “unlock” and keep on, at the same time revolve feeding tube clockwise. you will not be able
to dismantle feeding tube when sliding stall is not in place.
Method of use
Please install and use according to following steps:
Juice function
1. Connect the feeding tube with main body.
•
Aim the feeding tube at the marking on main body.
•
Revolve feeding tube counterclockwise from to . If you hear
click sound, it means that feeding tube has been installed correctly.
Aim the hexagonal screw shaft at the hole on main body, then push
it to the bottom.
2. Insert squeezing screw into the hole on the main body.
3. Insert squeezing cone into the feeding tube.
Pay attention to two salient on juice cone. Aim them at corresponding
indentation in feeding tube.
4. Install the cover of the feeding tube on feeding tube.
•
Aim three lock buckle on cover of feeding tube at three corre-
sponding gaps on feeding tube, then push feeding tube cover to the
bottom horizontally.
•
Revolve feeding tube cover counterclockwise until marked on
the feeding tube cover aim at marked on the feeding tube.
Feeding tube cover must be installed in place, otherwise it could fall off
during working process.
5. Place Juice container with handle under the juice outlet.
•
Put the juice container onto the plate.
Juice container should not be too full, otherwise juice could overflow
when you take out the juice container.
6. Put the pulp container under the pulp outlet nearing to juice con-
tainer.
7. Mount the tray on the top of the feeding tube. Tray is convenient to
add material, specially little granule food material like grapes, strawbe-
rries and so on.
