6
instruction concerning use of the appliance in a safe way and understand hazards involved; children shall
not play with appliance; cleaning and user maintenance shall not be made by children without supervision
.
If the power cord is damaged, or in case of failure and / or malfunction do not tamper with the unit. The
reparation must be done by manufacturer or by service center authorized by the manufacturer in order to
prevent any risk. Failure to comply with the above may compromise unit safety and invalidate the warranty.
-
This appliance is intended to be used in household and similar applications such as: staff kitchen areas in shops,
offices and other working environments; by clients in hotels, motels and other residential type environments; farm
houses, bed and breakfast type environments. The appliance is not intended to be operated by means of an
external timer or separate remote-control system.
-
Before every use, unroll the power cord. Use original spare parts and accessories only.
-
Do not subject the product to strong impacts, serious damages may result.
GENERAL INFORMATION
Do not connect the electric plug since the installation is not complete. Do not leave the appliance unattended
while it is running. Unplug after each use. Unplug unit by pulling the plug and not the power cord.
Do not immerse product in water or other liquids and avoid splashing liquids reach the unit.
Place on solid and stable surfaces and away from windows or drafts. Before carrying out any cleaning,
disconnect the unit from the electrical outlet. Do not obstruct in any way the protection grids.
Before each use, unroll the power cord. Do not insert anything through the protection grids.
DESCRIPTION G50048
1 Front protection grid
2 Fan
3 Rear protection grid
4 Motor protection
5 Remote control
6 Motor body
7 Ring for grid fixing
8 Upper tube
9 Lower tube
10 Base
11 Weight of base
12 Screws for the base
13 Drive shaft
14 Control panel
15 Rear grid stopper
16 Fan stopper
17 Grid fixing screw
19 Button OSC 20 Button MODE
21 Button TIMER
22 Button SPEED
23 Button ON/OFF
24 Light oscillation
25 Light Mode
26 Light Timer
ASSEMBLING
The fan motor can work even if the protective grids have not yet been assembled and fixed. To ensure the
maximum safety, perform the installation completely before operating.
1)
Place the lower tube (9) in the hole of the base (10).
2)
Turn the base upside down and place the weight of base (11) inside it, then fix parts with the screws (12).
3)
Insert the motor housing and the upper tube (8) in the lower tube (9); to connect the 2 parts screw
clockwise the upper tube in the lower tube.
4)
Place the rear grid (3) near the plastic of motor (4) with metal handle facing upwards. Fit the holes placed
in the central part of grid with the pins in plastic protection (4) and secure the parts with the stopper (15).
5)
Insert the fan (2) in the drive shaft (13) and thread the stopper (16) to the threaded end of the crankshaft.
6)
Loosen the screw (17) in the ring (7). Do not fully unscrew the screw.
7)
Place the retaining ring (7) around the rear grid (5) with the screw located at the bottom.
8)
Place the front grid (1) in front of the rear grid (5) matching the grooves on the ring (7) with the outer wires
of the grids. Tighten the screw fixing ring (17) to secure both the grids.
OPERATING
Once finished assembling the unit, place the fan following the safety instructions, then plug it to the electrical
outlet. The control panel (14) and the remote control (5) operate the various functions of the fan.
Press button
ON/OFF
(23). The fan switches on.
Press the button
SPEED
(22) to adjust the wind power different speeds.
1: low speed
2: medium speed
3: high speed
Summary of Contents for TOTAL BLACK REMOTE
Page 15: ...14...